Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT ASSEMBLY
  1. Connect each connector.

  1. Engage the clamp.



    E189578
  1. Engage the claw.

  1. Install the headlight assembly with the bolt and 2 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL FRONT BUMPER ASSEMBLY
(Click here)


3. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. INSTALL REAR NO. 3 FLOOR BOARD


    B227791
  1. Engage the 2 guides to install the rear No. 3 floor board.



5. INSTALL REAR DECK FLOOR BOX
  1. Install the rear deck floor box.



6. INSTALL REAR NO. 2 FLOOR BOARD


    B227788E01
  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



7. ADJUST HEADLIGHT AIMING
(Click here)


8. ADJUST FOG LIGHT AIMING
(Click here)