CAN COMMUNICATION SYSTEM > Power Steering ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Power Steering ECU Communication Stop Mode |
|
|


| 1.CHECK CAN BUS WIRE FOR DISCONNECTION (POWER STEERING ECU BRANCH WIRE) |
Turn the power switch off.
![]() |
Disconnect the power steering ECU connector.
| *1 | Front view of wire harness connector (to Power Steering ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L54-1 (CANH) - L54-7 (CANL) | Power switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
Turn the power switch on (IG).
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L54-6 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| *1 | Front view of wire harness connector (to Power Steering ECU) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
Turn the power switch off.
![]() |
Disconnect the power steering ECU connector.
| *1 | Front view of wire harness connector (to Power Steering ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A27-2 (PGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||