THEFT DETERRENT SYSTEM > Intrusion Sensor Cancel Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (INTRUSION SENSOR CANCEL SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Select the item below in the Data List and read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Intrusion Sens OFF SW | Intrusion sensor cancel switch/ON or OFF | ON: Intrusion sensor cancel switch on OFF: Intrusion sensor cancel switch off | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - MAP LIGHT ASSEMBLY) |
Disconnect the L8 main body ECU (multiplex network body ECU) and U3*4 or U13*5 map light assembly connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L8-8 (SSW1) - U3-7 (SOFF)*4 L8-8 (SSW1) - U13-1 (SOFF)*5 | Always | Below 1 Ω |
| U3-1 (GND1) - Body ground*4 U13-9 (GND1) - Body ground*5 | Always | Below 1 Ω |
| L8-8 (SSW1) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Main Body ECU (Multiplex Network Body ECU)) | *2 | Front view of wire harness connector (to Map Light Assembly (Intrusion Sensor)) |
| *3 | Front view of wire harness connector (to Map Light Assembly (Intrusion Sensor)) | *4 | w/o Sliding Roof System |
| *5 | w/ Sliding Roof System | - | - |
|
| ||||
| OK | |
| 3.INSPECT MAP LIGHT ASSEMBLY (INTRUSION SENSOR CANCEL SWITCH) |
![]() |
Remove the map light assembly (intrusion sensor cancel switch) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U3-7 (SOFF) - U3-1 (GND1)*3 U13-1 (SOFF) - U13-9 (GND1)*4 | Intrusion sensor ON (intrusion sensor cancel switch not pressed) | 10 kΩ or higher |
| U3-7 (SOFF) - U3-1 (GND1)*3 U13-1 (SOFF) - U13-9 (GND1)*4 | Intrusion sensor off (intrusion sensor cancel switch pressed) | Below 1 Ω |
| *1 | Component without harness connected (Map Light Assembly (Intrusion Sensor Cancel Switch)) |
| *2 | Component without harness connected (Map Light Assembly (Intrusion Sensor Cancel Switch)) |
| *3 | w/o Sliding Roof System |
| *4 | w/ Sliding Roof System |
|
| ||||
| OK | ||
| ||