Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Indicator Circuit

for Preparation Click here


DESCRIPTION

The headlight beam level control system indicator light in the combination meter assembly comes on for approximately 3 seconds when the power switch is turned to on (IG). The indicator light also comes on when the headlight leveling ECU assembly detects a malfunction.

WIRING DIAGRAM


E179219E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BATTERY - COMBINATION METER ASSEMBLY)


    E160303E50
  1. Disconnect the L27 combination meter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    L27-19 (IG+) - Body ground
    Power switch on (IG)
    11 to 14 V
    Power switch off
    Below 1 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Combination Meter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)
  1. Disconnect the A48 headlight leveling ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A48-6 (WNG) - L27-6 (LVWG)
    Always
    Below 1 Ω
    A48-6 (WNG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT NO. 3 METER CIRCUIT PLATE


    E191091E01
  1. Reconnect the L27 combination meter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    L27-6 (LVWG) - Body ground
    Power switch on (IG)
    11 to 14 V

    Text in Illustration 
    *1
    Component with harness connected
    (Combination Meter Assembly)



NG
REPLACE NO. 3 METER CIRCUIT PLATE (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)