LIGHTING SYSTEM > Indicator Circuit |

| 1.CHECK HARNESS AND CONNECTOR (BATTERY - COMBINATION METER ASSEMBLY) |
![]() |
Disconnect the L27 combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L27-19 (IG+) - Body ground | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V |
| *1 | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY) |
Disconnect the A48 headlight leveling ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A48-6 (WNG) - L27-6 (LVWG) | Always | Below 1 Ω |
| A48-6 (WNG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT NO. 3 METER CIRCUIT PLATE |
![]() |
Reconnect the L27 combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L27-6 (LVWG) - Body ground | Power switch on (IG) | 11 to 14 V |
| *1 | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | ||
| ||