Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use the following procedure to troubleshoot the wiper and washer system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT


      4.PROBLEM SYMPTOMS TABLE

        Result:
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B



      B.
      Go to step 6
      A


      5.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Terminals of ECU (Click here)

      2. Fail-safe chart (Click here)

      3. Inspection

      4. On-vehicle inspection


      NEXT


      6.ADJUST, REPAIR OR REPLACE

        NEXT


        7.CONFIRMATION TEST

          NEXT

          END