Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Odo/Trip Switch Malfunction

for Preparation Click here


DESCRIPTION

The meter ECU (No. 3 meter circuit plate) receives trip switch signals from the trip switch via the direct line in this circuit.

WIRING DIAGRAM


E188200E06


INSPECTION PROCEDURE

1.INSPECT TRIP SWITCH


    E192285E01
  1. Remove the trip switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (CS) - 12 (E)
    Unit change switch pressed
    Below 1 Ω
    1 (CS) - 12 (E)
    Unit change switch not pressed
    10 kΩ or higher
    9 (HOUR) - 12 (E)
    Hour adjust switch pressed
    Below 1 Ω
    9 (HOUR) - 12 (E)
    Hour adjust switch not pressed
    10 kΩ or higher
    10 (MIN) - 12 (E)
    Minute adjust switch pressed
    Below 1 Ω
    10 (MIN) - 12 (E)
    Minute adjust switch not pressed
    10 kΩ or higher
    11 (RST) - 12 (E)
    Set switch pressed
    Below 1 Ω
    11 (RST) - 12 (E)
    Set switch not pressed
    10 kΩ or higher

    Text in Illustration 
    *1
    Trip Switch (for RHD)
    *2
    Trip Switch (for LHD)
    *1
    Component without harness connected
    (Trip Switch)



NG
REPLACE TRIP SWITCH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (NO. 3 METER CIRCUIT PLATE - TRIP SWITCH)
  1. Disconnect the L27 and L57 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L27-2 (TC O) - L57-1 (CS)
    Always
    Below 1 Ω
    L27-2 (TC O) - Body ground
    Always
    10 kΩ or higher
    L27-12 (HOUR) - L57-9 (HOUR)
    Always
    Below 1 Ω
    L27-12 (HOUR) - Body ground
    Always
    10 kΩ or higher
    L27-13 (MIN) - L57-10 (MIN)
    Always
    Below 1 Ω
    L27-13 (MIN) - Body ground
    Always
    10 kΩ or higher
    L27-17 (RST) - L57-11 (RST)
    Always
    Below 1 Ω
    L27-17 (RST) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (NO. 3 METER CIRCUIT PLATE) (Click here)