AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
![]() |
Disconnect the No. 1 stereo jack adapter assembly and radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| SJ-4 (AUXO) - L50-19 (AUXI) | Always | Below 1 Ω |
| SJ-3 (ASGN) - L50-16 (ASGN) | Always | Below 1 Ω |
| SJ-2 (ARO) - L50-15 (ARI) | Always | Below 1 Ω |
| SJ-1 (ALO) - L50-17 (ALI) | Always | Below 1 Ω |
| SJ-5 (AGND) - L50-18 (AGND) | Always | Below 1 Ω |
| SJ-4 (AUXO) - Body ground | Always | 10 kΩ or higher |
| SJ-3 (ASGN) - Body ground | Always | 10 kΩ or higher |
| SJ-2 (ARO) - Body ground | Always | 10 kΩ or higher |
| SJ-1 (ALO) - Body ground | Always | 10 kΩ or higher |
| SJ-5 (AGND) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Radio Receiver Assembly) |
| *2 | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||