ENTRY AND START SYSTEM (for Entry Function) > Back Door Entry Lock Function does not Operate |

| 1.CHECK POWER DOOR LOCK OPERATION |
When the door control switch on the master switch assembly is operated, check that the doors unlock and lock according to switch operation (Click here).
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (BACK DOOR OPENER SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Display | Normal Condition | Diagnostic Note |
| Tr/B-Door Lock SW | Back door opener switch assembly (lock switch) / ON or OFF | ON: Back door opener switch assembly (lock switch) pushed OFF: Back door opener switch assembly (lock switch) not pushed | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY |
![]() |
Remove the back door opener switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 1 (L) - 2 (E) | Back door opener switch assembly (lock switch) not pushed (OFF) | 10 kΩ or higher |
| 1 (L) - 2 (E) | Back door opener switch assembly (lock switch) pushed (ON) | Below 1 Ω |
| *1 | Component without harness connected (Back Door Opener Switch Assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BACK DOOR OPENER SWITCH) |
![]() |
Disconnect the certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L62-23 (TSW6) - V4-1 (L) | Always | Below 1 Ω |
| L62-23 (TSW6) - Body ground | Always | 10 kΩ or higher |
| V4-1 (L) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
| *2 | Front view of wire harness connector (to Back Door Opener Switch Assembly) |
|
| ||||
| OK | ||
| ||