DTC C1515 Torque Sensor Zero Point Adjustment Undone |
DTC C1525 Rotation Angle Sensor Initialization Undone |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1515 | This DTC is detected when torque sensor zero point calibration has not been performed. | There is no malfunction if this DTC is not output again after performing zero point calibration. |
| C1525 | This DTC is detected when rotation angle sensor value initialization has not been performed. | There is no malfunction if this DTC is not output again after performing rotation angle sensor value initialization. |
| 1.INITIALIZE ROTATION ANGLE SENSOR VALUE AND CALIBRATE TORQUE SENSOR ZERO POINT |
Initialize the rotation angle sensor value and calibrate the torque sensor zero point (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTCs (Click here).
| Condition | Proceed to |
| DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times*1. | A |
| DTCs are still output even after performing rotation angle sensor value initialization and steering zero point calibration once or twice*2. | B |
| Normal system code is output. | C |
|
| ||||
|
| ||||
| A | |
| 3.REPLACE POWER STEERING ECU |
Replace the power steering ECU (Click here).
| NEXT | |
| 4.INITIALIZE ROTATION ANGLE SENSOR VALUE AND CALIBRATE TORQUE SENSOR ZERO POINT |
Initialize the rotation angle sensor value and calibrate the torque sensor zero point (Click here).
| NEXT | |
| 5.CHECK FOR DTC |
Check for DTCs (Click here).
| Condition | Proceed to |
| DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times*1. | A |
| DTCs are still output even after performing rotation angle sensor value initialization and steering zero point calibration twice*2. | B |
| Normal system code is output. | C |
|
| ||||
|
| ||||
| A | ||
| ||