Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1521    Motor Circuit Malfunction

DTC    C1531    ECU Malfunction

DTC    C1532    ECU Malfunction

DTC    C1533    ECU Malfunction

DTC    C1534    ECU Malfunction

for Preparation Click here


DESCRIPTION

If the power steering ECU detects these DTCs, it will shut off the motor relay circuit (built into the power steering ECU) and stop power assist. However, power assist continues if DTC C1533 or C1534 is output.

DTC No.
DTC Detection Condition
Trouble Area
C1521
Motor overcurrent
Power steering ECU
C1531
ECU internal malfunction (CPU malfunction)
C1532
ECU internal malfunction (Peripheral circuit malfunction)
C1533
ECU internal malfunction (Substrate temperature sensor malfunction)
C1534
ECU internal malfunction (EEPROM error)

INSPECTION PROCEDURE

NOTICE:
If the steering column assembly or power steering ECU has been replaced, perform the rotation angle sensor value initialization and torque sensor zero point calibration (Click here).

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs. (Click here)

    OK:
    DTC is not output.



NG
REPLACE POWER STEERING ECU (Click here)
OK

CHECK INTERMITTENT PROBLEMS