Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > INSPECTION

for Preparation Click here



1. INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C239105E01
  1. Remove the tire pressure warning reset switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (INT) - 2 (E)
    On
    Below 1 Ω
    Off
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Tire Pressure Warning Reset Switch)
    *b
    On
    *c
    Off