Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

DTC    B2764    Short to GND in Intrusion Sensor Signal Circuit

for Preparation Click here


DESCRIPTION

  1. The theft warning radar sensor (intrusion sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
    If a malfunction is detected in the ISIF line, the main body ECU (multiplex network body ECU) stores this DTC.

DTC No.
DTC Detection Condition
Trouble Area
B2764
After normal/trouble signal is output from intrusion sensor as result of self-diagnosis, following malfunctions are detected:
  1. ISIF line circuit is shorted to ground
  2. Reception of signals other than normal/trouble signal
  1. Theft warning radar sensor (intrusion sensor)
  2. Main body ECU (multiplex network body ECU)
  3. Wire harness or connector

WIRING DIAGRAM

Refer to DTC B2762 (Click here).

INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAP LIGHT ASSEMBLY - MAIN BODY ECU)


  1. Disconnect the L8 main body ECU (multiplex network body ECU) and U3*4 or U13*5 map light assembly connectors.


    B229083E03

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L8-12 (ISIF) - U3-6 (IOUT)*4
    L8-12 (ISIF) - U13-8 (IOUT)*5
    Always
    Below 1 Ω
    U3-1 (GND1) - Body ground*4
    U13-9 (GND1) - Body ground*5
    Always
    Below 1 Ω
    L8-12 (ISIF) - Body ground
    Always
    10 kΩ or higher

    1. *4: w/o Sliding Roof System
    2. *5: w/ Sliding Roof System

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Main Body ECU (Multiplex Network Body ECU))
    *2
    Front view of wire harness connector
    (to Map Light Assembly (Intrusion Sensor))
    *3
    Front view of wire harness connector
    (to Map Light Assembly (Intrusion Sensor))
    *4
    w/o Sliding Roof System
    *5
    w/ Sliding Roof System
    -
    -



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.REPLACE THEFT WARNING RADAR SENSOR (INTRUSION SENSOR)
  1. Replace the theft warning radar sensor (intrusion sensor) (Click here).


NEXT


3.CHECK FOR DTC
  1. Check if DTC B2764 is not output (Click here).

    OK:
    DTC B2764 is not output.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (THEFT WARNING RADAR SENSOR (INTRUSION SENSOR) WAS FAULTY)