DTC C1A0A Front Radar Sensor Region Code Mismatch |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1A0A | While power switch is on (IG), country specification information in driving support ECU and millimeter wave radar sensor do not match for 1 second |
|
| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Radar Cruise / Data List / Country# (F Radar Sens).
Read the Data List and check the country specification information of the front millimeter wave radar sensor and vehicle.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Country# (F Radar Sens) | Millimeter wave radar sensor country signal/JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC, NOFIX | Actual country code | - |
| Result | Proceed to |
| Country specification information for vehicle and millimeter wave radar sensor match | A |
| Country specification information for vehicle and millimeter wave radar sensor do not match | B |
|
| ||||
| A | |
| 2.CHECK WHETHER DTC OUTPUT RECURS (DTC C1A0A) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A0A is output | B |
|
| ||||
| A | ||
| ||