Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM

DTC    C1A10    Front Radar Sensor

for Preparation Click here


DESCRIPTION

The driving support ECU uses the millimeter wave radar sensor to detect obstacles in front of the vehicle.
When the driving support ECU receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stared.

DTC Code
DTC Detection Condition
Trouble Area
C1A10
While power switch is on (IG), driving support ECU receives information that there is malfunction in millimeter wave radar sensor assembly for 1 second
  1. Millimeter wave radar sensor assembly
  2. Driving support ECU

INSPECTION PROCEDURE

NOTICE:
When the millimeter wave radar sensor is replaced with a new one, adjustment of the front sensor beam axis must be performed (Click here).

1.REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
  1. Replace the millimeter wave radar sensor assembly (Click here).


NEXT


2.ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
  1. Adjust the millimeter wave radar sensor assembly (Click here).


NEXT


3.CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed of 40 km/h (25 mph) or more.

    2. Turn the cruise control main switch on.

    3. Push the -SET switch to activate the cruise control.

  1. Enter the following menus: Powertrain / Radar Cruise / DTC.

  1. Read the DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC C1A10 is output
    B



B
REPLACE DRIVING SUPPORT ECU (Click here)
A

END