DTC C1A50 Brake System |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1A50 | When signal malfunction from brake booster with master cylinder (skid control ECU) continues for 1 second while dynamic radar cruise control is operating |
|

| 1.READ OUTPUT DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK WHETHER DTC OUTPUT RECURS (DTC C1A50) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A50 is output | B |
|
| ||||
| A | ||
| ||
| 3.REPLACE DRIVING SUPPORT ECU |
Replace the driving support ECU (Click here).
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC C1A50) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A50 is output | B |
|
| ||||
| A | ||
| ||
| 5.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER |
Replace the brake booster with master cylinder (skid control ECU) (Click here for LHD, Click here for RHD).
| NEXT | |
| 6.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A50 is output | B |
|
| ||||
| A | ||
| ||