Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD)

BRAKE PEDAL (for LHD) > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY


    C209159
  1. Install the nut to the brake pedal support assembly.



    C205689
  1. Install the brake pedal support assembly with the 4 nuts.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



    C205691
  1. Engage the clamp and connect the connector to the brake pedal stroke sensor assembly.



    C205685E01
  1. Install the brake pedal support assembly to the instrument panel reinforcement with the bolt.
    Text in Illustration 
    *1
    Bolt Width
    Bolt Variation
    Bolt Width
    Bolt A
    14 mm (0.551 in.)
    Bolt B
    12 mm (0.472 in.)

    Torque:
    for Bolt A:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }
    for Bolt B:
    24 N*m{ 241 kgf*cm , 17 ft.*lbf }

    HINT:
    Two types of bolts each with a different torque specification are used.



2. INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY


    C205686
  1. Install the driver side junction block assembly with the bolt and nut.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }



3. INSTALL PUSH ROD PIN
  1. Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal sub-assembly.



    C205688
  1. Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal sub-assembly.



4. INSTALL BRAKE PEDAL RETURN SPRING


    C205687
  1. Install the brake pedal return spring to the brake pedal support sub-assembly and push rod pin.



5. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER


6. INSTALL STOP LIGHT SWITCH ASSEMBLY


    E167768
  1. Insert the stop light switch assembly until the rod hits the pedal.

    NOTICE:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



    E167769
  1. Make a quarter turn clockwise to install the stop light switch assembly.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    NOTICE:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

  1. Connect the connector.

  1. Check the protrusion of the rod.

    Protrusion of the rod:
    1.5 to 2.5 mm (0.0591 to 0.0984 in.)

    If the protrusion is not as specified, adjust it.

    NOTICE:
    Do not depress the brake pedal.



7. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY

HINT:
Refer to the instructions for Installation of the upper instrument panel assembly (Click here).



8. INSPECT AND ADJUST BRAKE PEDAL

HINT:
Click here



9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Connect each connector.



    B223658
  1. Engage the guide and claw.

  1. Install the No. 1 instrument panel under cover sub-assembly with the 2 screws <D>.



10. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE

HINT:
Click here