Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD)

BRAKE PEDAL (for LHD) > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY


    C209159
  1. Install the nut to the brake pedal support assembly.



    C205689
  1. Install the brake pedal support assembly with the 4 nuts.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



    C205691
  1. Engage the clamp and connect the connector to the brake pedal stroke sensor assembly.



    C205685E01
  1. Install the brake pedal support assembly to the instrument panel reinforcement with the bolt.
    Text in Illustration 
    *1
    Bolt Width
    Bolt Variation
    Bolt Width
    Bolt A
    14 mm (0.551 in.)
    Bolt B
    12 mm (0.472 in.)

    Torque:
    for Bolt A:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }
    for Bolt B:
    24 N*m{ 241 kgf*cm , 17 ft.*lbf }

    HINT:
    Two types of bolts each with a different torque specification are used.



2. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    C205686
  1. Install the instrument panel junction block assembly with the bolt and nut.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }



3. INSTALL PUSH ROD PIN
  1. Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.



    C205688
  1. Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal support assembly.



4. INSTALL BRAKE PEDAL RETURN SPRING


    C205687
  1. Install the brake pedal return spring to the brake pedal support assembly and push rod pin.



5. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER


6. INSTALL STOP LIGHT SWITCH ASSEMBLY


    E167768
  1. Insert the stop light switch assembly until the threaded sleeve hits the pedal.

    NOTICE:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



    E236346E01
  1. Make a quarter turn clockwise to install the stop light switch assembly.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    NOTICE:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

  1. Connect the connector.

  1. Check the protrusion of the plunger.
    Protrusion of Plunger 
    Area
    Measurement
    a
    0.5 to 2.6 mm (0.0197 to 0.102 in.)
    If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (Click here for LHD or Click here for RHD).

    NOTICE:
    Do not depress or support the brake pedal.



7. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY
(Click here)


8. INSPECT AND ADJUST BRAKE PEDAL
(Click here)


9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Connect each connector.

  1. Engage the guide and claw.

  1. Install the No. 1 instrument panel under cover sub-assembly with the 2 screws <D>.



10. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE
(Click here)