Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR


    A216698E01
  1. Using SST, install the air fuel ratio sensor.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.



    A212298
  1. Connect the air fuel ratio sensor connector and clamp.



2. INSTALL NO. 2 CYLINDER HEAD COVER


    A213020
  1. Engage the 3 clips to install the cover.

    NOTICE:
    1. Be sure to engage the clips securely.
    2. Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.



3. INSPECT FOR EXHAUST GAS LEAK


4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    C209144
  1. Install the outer cowl top panel sub-assembly with the 9 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    C209145
  1. Bend the water guard plate RH and engage the claw.



    C209147
  1. Bend the No. 1 heater air duct splash shield seal and engage the claw.



    C205696
  1. Engage the clamp to install the wire harness.



5. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    C205557
  1. Install the outer cowl top panel with the 9 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    C205561
  1. Bend the water guard plate RH and engage the claw.



    C205559
  1. Bend the No. 1 heater air duct splash shield seal and engage the claw.



    C205555E01
  1. Engage the clamp*2 of the wire harness.

  1. Engage the clamp*1 and connect the connector (w/ Windshield Deicer).



    C205556
  1. Engage the clamp of the wire harness.



6. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
  1. Install the windshield wiper motor and link (Click here).