EXHAUST HEAT RECIRCULATION SYSTEM > Exhaust Heat Recirculation System Circuit |

| 1.CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR - METER CIRCUIT PLATE) |
![]() |
Disconnect the engine coolant temperature sensor connector.
Disconnect the No. 3 meter circuit plate connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G2-2 (TWS3) - L27-16 (TWS3) | Always | Below 1 Ω |
| G2-1 (E2) - L27-9 (E2) | Always | Below 1 Ω |
| Tester Condition | Condition | Specified Condition |
| G2-2 (TWS3) or L27-16 (TWS3) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to No. 3 Meter Circuit Plate) |
| *2 | Front view of wire harness connector (to Engine Coolant Temperature Sensor) |
Reconnect the No. 3 meter circuit plate connector.
Reconnect the engine coolant temperature sensor connector.
|
| ||||
| OK | |
| 2.INSPECT ENGINE COOLANT TEMPERATURE SENSOR |
Inspect the engine coolant temperature sensor (Click here).
|
| ||||
| OK | ||
| ||