DTC C1612 IG Voltage is Low or High |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1612 |
|
|

| 1.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Check for DTCs (Click here).
| Result | Proceed to |
| DTC C1612 is output | A |
| DTCs are not output | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU IG VOLTAGE) |
![]() |
Disconnect the L152 connector from the parking assist ECU.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L152-8 (IG) - L152-4 (GND1) | Power switch on (IG) | 11 to 14 V |
| *a | Front view of wire harness connector (to Parking Assist ECU) |
|
| ||||
| OK | ||
| ||