Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

DTC    C1625    Open or Short in Steering Angle Sensor +B

for Preparation Click here


DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral cable with sensor sub-assembly that indicates a power supply system problem.

DTC No.
DTC Detection Condition
Trouble Area
C1625
Open or short in steering angle sensor +B
  1. Harness or connector
  2. Steering angle sensor (spiral cable with sensor sub-assembly)

WIRING DIAGRAM


E224380E10


INSPECTION PROCEDURE

NOTICE:
  1. When the "System initializing" message is displayed on the navigation ECU sub-assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (Click here).
  3. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY POWER SUPPLY)
  1. Disconnect the L51 connector from the spiral cable with sensor sub-assembly.



    E228131E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L51-2 (ESS) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L51-5 (IG1) - L51-2 (ESS)
    Power switch on (IG)
    11 to 14 V
    L51-6 (BAT) - L51-2 (ESS)
    Power switch off
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Spiral Cable with Sensor Sub-assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (Click here)