INTELLIGENT PARKING ASSIST SYSTEM > Message indicating Back Door is Open is Displayed even after Back Door is Closed |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Check for proper functioning of the following item using the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Back Door Courtesy SW | Back door courtesy switch signal/ON or OFF | ON: Back door open OFF: Back door closed | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - BACK DOOR LOCK ASSEMBLY) |
Disconnect the L7 connector from the main body ECU (multiplex network body ECU).
Disconnect the R18 connector from the back door lock assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L7-19 (BCTY) - R18-2 (+) | Always | Below 1 Ω |
| L7-19 (BCTY) - Body ground | Always | 10 kΩ or higher |
| R18-1 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT BACK DOOR LOCK ASSEMBLY |
Remove the back door lock assembly (Click here).
![]() |
Check the operation of the door lock motor.
Move the door lock to the lock position.
Apply auxiliary battery voltage to the door lock motor and check the operation of the door lock motor.
| Connection | Result |
| Auxiliary battery positive (+) → 4 (ACT+) Auxiliary battery negative (-) → 3 (ACT-) | Unlocks |
Check the operation of the door courtesy switch.
Measure the resistance according to the value(s) in the table below.
| Measurement Condition | Condition | Specified Condition |
| 1 (E) - 2 (+) | Locked | 10 kΩ or higher |
| 1 (E) - 2 (+) | Unlocked | Below 1 Ω |
| *a | Lock |
| *b | Unlock |
| *c | Component without harness connected (Back Door Lock Assembly) |
|
| ||||
| OK | ||
| ||