DTC B15D8 Monitor Disconnected |
| DTC No. | DTC Detection Condition | Trouble Area |
| B15D8 | Parking assist ECU is not/was not connected while the power switch is turned on (ACC or IG). |
|

| 1.CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING) |
Check for optional components.
Check that optional components (including associated wiring) which generate radio waves are not installed.
| Result | Proceed to |
| Optional components (including associated wiring) are installed. | A |
| Optional components (including associated wiring) are not installed. | B |
|
| ||||
| A | |
| 2.REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING) |
Remove optional components (including associated wiring).
| NEXT | |
| 3.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU POWER SOURCE) |
![]() |
Disconnect the L65 parking assist ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L65-3 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L65-1 (+B) - L65-3 (GND1) | Power switch off | 11 to 14 V |
| L65-7 (IG) - L65-3 (GND1) | Power switch on (IG) | 11 to 14 V |
| L65-8 (ACC) - L65-3 (GND1) | Power switch on (ACC) | 11 to 14 V |
| *1 | Front view of wire harness connector (to Parking Assist ECU) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - NAVIGATION RECEIVER ASSEMBLY) |
![]() |
Disconnect the L65 parking assist ECU connector.
![]() |
Disconnect the L41 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L65-25 (TX+) - L41-9 (TX1+) | Always | Below 1 Ω |
| L65-24 (TX-) - L41-10 (TX1-) | Always | Below 1 Ω |
| L65-25 (TX+) - Body ground | Always | 10 kΩ or higher |
| L65-24 (TX-) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Parking Assist ECU) |
| *2 | Front view of wire harness connector (to Navigation Receiver Assembly) |
|
| ||||
| OK | |
| 6.REPLACE PARKING ASSIST ECU |
Replace the parking assist ECU (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||