SOLAR VENTILATION SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Air Conditioner / Data List.
Check the value(s) by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Solar Ventilation Switch | Solar ventilation switch (Switch recognition value at A/C amplifier side) / OFF or ON | OFF: Solar ventilation switch off ON: Solar ventilation switch on | - |
| Solar Voltage | Solar panel voltage / 10V les, 10V-11V, 11V-12V, 12V-13V, 13V-14V, 14V-15V, 15V-16V, 16V-17V, 17V-18V, 18V-19V, 19V-20V, 20V-21V, 21V-22V, 22V-23V or 23V ovr | Actual generated voltage displayed | System operation requirements are met (Click here). |
| Solar Ventilation Switch Status | Solar ventilation switch (Switch recognition value at solar ventilation ECU side) / OFF or ON | OFF: Solar ventilation switch off ON: Solar ventilation switch on | - |
| Solar IG Status | Solar ventilation ECU IG status / OFF or ON | OFF: Power switch off ON: Power switch on (IG) | When OFF is displayed, a malfunction in the solar ventilation ECU is suspected. |
| Solar Ventilation Test Mode Status | Solar ventilation ECU test mode status / OFF or ON | OFF: Test mode off ON: Test mode on | - |
| ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Air Conditioner / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Blower Motor | Blower motor | Min.: 0, Max.: 31 | - |