Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR VENTILATION SYSTEM

SOLAR VENTILATION SYSTEM > Communication Circuit between Solar Ventilation ECU and A/C Amplifier

for Preparation Click here


DESCRIPTION

The solar ventilation ECU communicates with the A/C amplifier using a direct line. The A/C amplifier checks the condition of the solar ventilation system based on signals sent via the direct line.
When this circuit malfunctions, Data List items for the solar ventilation system will not be displayed.

WIRING DIAGRAM


E191634E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SOLAR VENTILATION ECU - A/C AMPLIFIER)


    E180506E18
  1. Disconnect the solar ventilation ECU connector.



    E177002E75
  1. Disconnect the A/C amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L22-17 (SIND) - L17-26 (SSLR)
    Always
    Below 1 Ω
    L22-17 (SIND) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Solar Ventilation ECU)
    *2
    Front view of wire harness connector
    (to A/C Amplifier)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.REPLACE SOLAR VENTILATION ECU
  1. Replace the solar ventilation ECU with a known good one and check if the same problem occurs again (Click here).

    OK:
    Same problem does not occur.



NG
REPLACE A/C AMPLIFIER (Click here)
OK

END (SOLAR VENTILATION ECU WAS DEFECTIVE)