Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › BLOCKING SYSTEM

DTC    B15C0    Short in GPS Antenna

DTC    B15C1    Open in GPS Antenna

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the instrument panel integration antenna assembly (GPS antenna) circuit.

DTC No.
DTC Detection Condition
Trouble Area
B15C0
There is a short circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna), or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly.
  1. Telephone transceiver assembly
  2. Instrument panel integration antenna assembly (GPS antenna)
B15C1
There is an open circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna), or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly.

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the telephone transceiver assembly or instrument panel integration antenna assembly, refer to the Service Bulletin.
  2. When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.

1.CHECK CONNECTION OF CONNECTOR
  1. Turn the power switch off.

  1. Check that the connectors are properly connected to the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna).

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    OK:
    DTC B15C0 and B15C1 are not output.



NG
Go to step 4
OK

USE SIMULATION METHOD TO CHECK 

4.CHECK CONNECTOR CONDITION
  1. Turn the power switch off.



  1. Disconnect the telephone transceiver assembly (GPS antenna) connector.


    B319602E05


    Text in Illustration 
    *1
    GPS antenna
    -
    -
    *a
    Component without harness connected
    (Telephone Transceiver Assembly)
    -
    -

  1. Check that the connector pins are not bent.

    OK:
    Connector pins are not bent.



NG
REPAIR OR REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
OK


5.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


6.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    OK:
    DTC B15C0 and B15C1 is not output.



NG
Go to step 7
OK

USE SIMULATION METHOD TO CHECK 

7.REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
  1. Temporarily replace the instrument panel integration antenna assembly with a new or known good one.

    HINT:
    Refer to the Service Bulletin.


NEXT


8.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


9.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    OK:
    DTC B15C0 and B15C1 is not output.



NG
REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
OK

END (INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY WAS DEFECTIVE)