DTC B1573 Short in Telephone Antenna Circuit |
DTC B15CB Telematics Transceiver Antenna Disconnected |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1573 | There is a short circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and telephone antenna, or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly. |
|
| B15CB | There is an open circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and telephone antenna, or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly. |
| 1.CHECK CONNECTION OF CONNECTOR |
Turn the power switch off.
Check that the connectors are properly connected to the telephone transceiver assembly and instrument panel integration antenna assembly (telephone antenna connector).
|
| ||||
| OK | |
| 2.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 3.CHECK DTC OUTPUT |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.CHECK CONNECTOR CONDITION |
Turn the power switch off.
Disconnect the telephone transceiver assembly (telephone antenna) connector.

| *1 | Telephone antenna | - | - |
| *a | Component without harness connected (Telephone Transceiver Assembly) | - | - |
Check that the connector pins are not bent.
|
| ||||
| OK | |
| 5.CHECK INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY (TELEPHONE ANTENNA) |
![]() |
Disconnect the instrument panel integration antenna assembly (telephone antenna) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Core wire - Shield | Always | 4 to 11 kΩ |
| *1 | Core wire |
| *2 | Shield |
| *a | Component without harness connected (Instrument Panel Integration Antenna Assembly (Telephone Antenna)) |
|
| ||||
| OK | |
| 6.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 7.CHECK DTC OUTPUT |
Wiggle the instrument panel integration antenna assembly (telephone antenna).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 8.REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY |
Temporarily replace the instrument panel integration antenna assembly with a new or known good one.
| NEXT | |
| 9.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 10.CHECK DTC OUTPUT |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||