DTC B1586 Open in Immobiliser Communication Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1586 | The communication line (EFIO - BLK4) between the ID code box (immobiliser code ECU) and telephone transceiver assembly is open. |
|

| 1.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Turn the power switch off.
Turn the power switch on (IG).
After 6 seconds have elapsed, check for DTCs.
| Result | Proceed to |
| DTC is not output. | A |
| Only DTC B1586 is output. | B |
| DTC B1586 and other DTCs are output. | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 2.CHECK CONNECTION OF CONNECTOR |
Turn the power switch off.
Check that the connectors are properly connected to the telephone transceiver assembly and ID code box (immobiliser code ECU).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - ID CODE BOX (IMMOBILISER CODE ECU)) |
Disconnect the L156 telephone transceiver assembly connector.
Disconnect the L10 ID code box (immobiliser code ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L156-2 (BLK4) - L10-6 (EFIO) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK ID CODE BOX (IMMOBILISER CODE ECU) (OUTPUT) |
Reconnect the L156 telephone transceiver assembly connector.
Reconnect the L10 ID code box (immobiliser code ECU) connector.
Using an oscilloscope, check the waveform.

| *a | Component with harness connected (ID Code Box (Immobiliser Code ECU)) | *b | Approximately 160 ms |
| *c | Approximately 510 ms | - | - |
| Item | Content |
| Tester Connection | L10-6 (EFIO) - L10-8 (GND) |
| Tool Setting | 2 V/DIV., 500 ms./DIV. |
| Condition | Within 3 seconds of power switch on (READY), or within 3 seconds of power switch turned on (IG) after auxiliary battery cable disconnected and reconnected |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - AUXILIARY BATTERY AND BODY GROUND) |
Disconnect the L156 telephone transceiver assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L156-9 (E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| L156-12 (+B) - Body ground | Power switch off | 11 to 14 V |
| L156-6 (IG2) - Body ground | Power switch off | Below 1 V |
| L156-6 (IG2) - Body ground | Power switch on (IG) | 11 to 14 V |
|
| ||||
| OK | |
| 6.REPLACE ID CODE BOX (IMMOBILISER CODE ECU) |
Temporarily replace the ID code box (immobiliser code ECU) with a new one.
| NEXT | |
| 7.PERFORM REGISTRATION |
Perform the registration.
| NEXT | |
| 8.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Turn the power switch off.
Turn the power switch on (IG).
After 10 seconds have elapsed, check for DTCs.
|
| ||||
| OK | ||
| ||