DTC B1587 Lost Communication for Immobiliser Communication Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1587 | Either condition is met:
|
|

| 1.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Turn the power switch off.
Start the hybrid system.
Check for DTCs.
|
| ||||
| OK | ||
| ||
| 2.REREGISTER ECU COMMUNICATION ID |
Reregister the ECU communication ID.
| NEXT | |
| 3.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Turn the power switch off.
Start the hybrid system.
Check for DTCs.
|
| ||||
| OK | ||
| ||
| 4.CHECK CONNECTION OF CONNECTOR |
Turn the power switch off.
Check that the connectors are properly connected to the telephone transceiver assembly and ID code box (immobiliser code ECU).
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - ID CODE BOX (IMMOBILISER CODE ECU)) |
Disconnect the L10 ID code box (immobiliser code ECU) connector.
Disconnect the L156 telephone transceiver assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L156-1 (BLK1) - L10-5 (EFII) | Always | Below 1 Ω |
| L156-1 (BLK1) - Body ground | Always | 10 kΩ or higher |
| L10-5 (EFII) - Body ground | Always | 10 kΩ or higher |
| L156-2 (BLK4) - L10-6 (EFIO) | Always | Below 1 Ω |
| L156-2 (BLK4) - Body ground | Always | 10 kΩ or higher |
| L10-6 (EFIO) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| L156-1 (BLK1) - Body ground | Always | Below 1 V |
| L156-2 (BLK4) - Body ground | Always | Below 1 V |
|
| ||||
| OK | |
| 6.REPLACE ID CODE BOX (IMMOBILISER CODE ECU) |
Temporarily replace the ID code box (immobiliser code ECU) with a new one.
| NEXT | |
| 7.REGISTER ECU COMMUNICATION ID |
Register the ECU communication ID.
| NEXT | |
| 8.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Turn the power switch off.
Start the hybrid system.
Check for DTCs.
|
| ||||
| OK | ||
| ||