Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY RH

HINT:
Refer to the procedure from Temporarily Tighten Front No. 1 Lower Suspension Arm Sub-assembly RH .



2. TEMPORARILY TIGHTEN FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH


    C205613
  1. Temporarily install the front No. 1 lower suspension arm LH to the front suspension crossmember with the 2 bolts and nut.

    NOTICE:
    Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



3. CONNECT FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH


    C205578
  1. Install the front No. 1 lower suspension arm sub-assembly to the front lower ball joint with the bolt and 2 nuts.

    Torque:
    89 N*m{ 908 kgf*cm , 66 ft.*lbf }



4. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



5. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



6. FULLY TIGHTEN FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH


    C212310E02
  1. Fully tighten the bolt A and B.

    Torque:
    Bolt A:
    233 N*m{ 2376 kgf*cm , 172 ft.*lbf }
    Bolt B:
    214 N*m{ 2182 kgf*cm , 158 ft.*lbf }

    NOTICE:
    Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



7. INSTALL NO. 1 ENGINE UNDER COVER


8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
Inspect and adjust the front wheel alignment (Click here).