Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat)

FRONT SEAT ASSEMBLY (for Manual Seat) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover or separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



5. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. REMOVE FRONT SEAT HEADREST ASSEMBLY


7. REMOVE OUTER SEAT TRACK COVER
  1. Lift up the seat track adjusting handle and move the seat to the foremost position.



    B229805
  1. Disengage the 2 claws and remove the outer seat track cover.



8. REMOVE INNER SEAT TRACK COVER


    B229803
  1. Disengage the claw and guide, remove the inner seat track cover.



9. REMOVE FRONT SEAT ASSEMBLY


    B229807
  1. Remove the 2 bolts on the rear side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B229808
  1. Remove the 2 bolts on the front side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

  1. w/ Vertical Adjuster:

    1. Lift up the vertical adjusting handle and move the seat to upright position.

  1. Disconnect each connector and clamp under the seat.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.