SFI SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
![]() |
| NORMAL MODE AND CHECK MODE |
| 2 TRIP DETECTION LOGIC |
| DLC3 (Data Link Connector 3) |
Check DLC3 (Click here).
| FREEZE FRAME DATA |
| AUXILIARY BATTERY VOLTAGE |
| MIL (Malfunction Indicator Lamp) |
The MIL illuminates when the power switch is turned on (IG).
When the READY indication turns on, the MIL should turns off. If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.
| ALL READINESS |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Clear DTCs (Click here).
Turn the power switch off and wait for 30 seconds.
Turn the power switch on (IG) and turn the Techstream on.
Perform the DTC judgment driving pattern to run the DTC judgment.
Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
Input the DTCs to be confirmed.
Check the DTC judgment result.
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|