CRUISE CONTROL SYSTEM > SYSTEM DESCRIPTION |
| CRUISE CONTROL SYSTEM |
![]() |
| *1 | Cruise Main Indicator Light |
| *2 | "SET" Indicator |
| LIMIT CONTROL |
Low speed limit
The lowest possible limit of the speed setting range is set at approximately 40 km/h (25 mph). The cruise control system cannot be set when the vehicle speed is below the low speed limit. Cruise control operation will be automatically canceled but the stored vehicle speed will be retained when the vehicle speed drops below the low speed limit of 40 km/h (25 mph) while the cruise control is in operation.
High speed limit
The highest possible limit of the speed setting range is set at approximately 200 km/h (125 mph). The cruise control system cannot be set when the driving vehicle speed is over the high speed limit. Also, + RES cannot be used to increase speed over the high speed limit.
| CRUISE CONTROL OPERATION |
SET CONTROL
Vehicle speed is stored and constant speed control is maintained when pushing the cruise control main switch to - SET while driving with the main switch on (the cruise main indicator light comes on), and the vehicle speed is within the set speed range (between the low and high speed limits).
- CONTROL
The power management control ECU decreases the cruise control demand speed and controls the engine and motor driving force to decelerate the vehicle when - SET on the cruise control main switch is pressed and held while the cruise control system is in operation. When the cruise control main switch is released from - SET, vehicle speed is stored and constant speed control is maintained.
TAP-DOWN CONTROL
When tapping down the cruise control main switch to - SET (for approximately 0.6 seconds) while the cruise control system is in operation, the stored vehicle speed decreases each time by approximately 1.6 km/h (1 mph). When the cruise control main switch is released from - SET and the difference between the driving and stored vehicle speeds is more than approximately 5 km/h (3 mph), the vehicle speed is stored and constant speed control is maintained.
+ CONTROL
The power management control ECU increases the cruise control demand speed and controls the engine and motor driving force to accelerate the vehicle when pushing and holding the cruise control main switch to + RES while the cruise control system is in operation.
When the cruise control main switch is released from + RES, vehicle speed is stored and constant speed control is maintained.
TAP-UP CONTROL
When tapping up the cruise control main switch to + RES (for approximately 0.6 seconds) while the cruise control system is in operation, the stored vehicle speed increases each time by approximately 1.6 km/h (1 mph). However, when the difference between the driving and the stored vehicle speeds is more than approximately 5 km/h (3 mph), the stored vehicle speed will not be changed.
RES CONTROL
If cruise control operation was canceled with the stop light switch assembly or the CANCEL switch, and if driving speed is within the limit range, pushing the cruise control main switch to + RES restores vehicle speed memorized at the time of cancellation, and maintains constant speed control.
MANUAL CANCEL CONTROL
Performing any of the following cancels the cruise control system while it is operating (the stored vehicle speed in the ECM is maintained).
| AUTO CANCEL (FAIL-SAFE) |