CURTAIN SHIELD AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (When Installed in Vehicle) |
![]() |
Check the function of SST .
Refer to Precaution (Click here).
Disconnect the cable from the negative (-) auxiliary battery terminal.
Remove the roof headlining assembly (Click here).
Install SST.
Disconnect the connector from the curtain shield airbag assembly.
![]() |
After connecting the following SST to each other, connect them to the curtain shield airbag assembly.
![]() |
Move SST at least 10 m (32.8 ft.) away from the rear side window.
| *1 | Battery |
Maintaining sufficient clearance for the SST wire harness in the rear side window, close all doors and windows of the vehicle.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Press the SST activation switch and deploy the airbag.
| 3. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (When Not Installed in Vehicle) |
![]() |
Check the function of SST .
Remove the curtain shield airbag assembly (Click here).
![]() |
Cut off the deployment section of the curtain shield airbag assembly.
![]() |
Using braided wire, tie down the curtain shield airbag assembly to an unneeded tire.
| *1 | Stripped Wire Section |
| *2 | Wire Diameter |
![]() |
Position the curtain shield airbag assembly inside the tire as shown in the illustration.
| *1 | Width |
| *2 | Inner Diameter |
Install SST.
![]() |
After connecting the following SST to each other, connect them to the curtain shield airbag assembly.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the curtain shield airbag assembly is tied.
Place at least 2 tires onto the tire to which the curtain shield airbag assembly is tied. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
Install SST.
![]() |
Connect the SST connector.
| *1 | Curtain Shield Airbag Assembly |
| *2 | Battery |
Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
Deploy the airbag.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the curtain shield airbag assembly is tied.
Press the SST activation switch and deploy the airbag.
![]() |
Dispose of the curtain shield airbag assembly.
Remove the curtain shield airbag assembly from the tire.
Place the curtain shield airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.