CRUISE CONTROL MAIN SWITCH > REMOVAL |
| 1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 2. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 3. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 5. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw to remove the lower No. 3 steering wheel cover.
| *1 | Protective Tape |
| 6. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw to remove the lower No. 2 steering wheel cover.
| *1 | Protective Tape |
| 7. REMOVE STEERING PAD |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Using a screwdriver, push the torsional spring to disengage the 2 pins.
| *1 | Torsional Spring |
![]() |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.
Disconnect the horn connector from the steering pad.
Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.
| *1 | Protective Tape |
Disconnect the 2 airbag connectors to remove the steering pad.
| 8. REMOVE CRUISE CONTROL MAIN SWITCH |
![]() |
Disconnect the connector.
![]() |
Remove the 2 screws and cruise control main switch.