DTC B2001 Short to GND in Seat Belt Motor RH Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2001 | Short to ground in the seat belt motor RH circuit continues for 1 second or more. |
|

| 1.INSPECT FRONT SEAT OUTER BELT ASSEMBLY RH |
![]() |
Disconnect the front seat outer belt assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S7-1 - Body ground | Always | 1 MΩ or higher |
| S7-2 - Body ground | Always | 1 MΩ or higher |
Reconnect the front seat outer belt assembly RH connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY RH - SEAT BELT CONTROL ECU) |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the front seat outer belt assembly RH connector.
Disconnect the seat belt control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S7-1 - Body ground | Always | 1 MΩ or higher |
| S7-2 - Body ground | Always | 1 MΩ or higher |
| S7-1 - S7-2 | Always | 1 MΩ or higher |
| *1 | Front view of wire harness connector (to Front Seat Outer Belt Assembly RH) |
Reconnect the seat belt control ECU and front seat outer belt assembly RH connectors.
Connect the cable to the negative (-) battery terminal.
|
| ||||
| OK | ||
| ||