Home › Vehicle Interior › PRE-COLLISION › SEAT BELT CONTROL ECU

SEAT BELT CONTROL ECU > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



2. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



3. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B237541E01
  1. Disengage the claw and release the glove compartment door stopper.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly
    *2
    Moulding Remover
    *3
    Lower Instrument Panel Sub-assembly
    *4
    Glove Compartment Door Assembly
    *5
    Stopper

  1. Insert the moulding remover into the location shown in the illustration.

  1. Move the moulding remover in the direction indicated by the arrow to bend the lower instrument panel sub-assembly and release the stopper (A).

    HINT:
    Use the same procedure to release the stopper (B).



    B223649E01
  1. Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.
    Text in Illustration 
    *a
    Close
    *b
    Open Approximately

    NOTICE:
    Pulling the glove compartment door assembly upward to remove it causes the hinges to deform. Be sure to pull out the glove compartment door assembly horizontally.



6. REMOVE ECU INTEGRATION BOX RH


    E188646
  1. Remove the bolt and 2 nuts.

  1. Disconnect each connector and remove the ECU integration box RH.



7. REMOVE SEAT BELT CONTROL ECU


    E188649
  1. Disengage the 2 claws and remove the seat belt control ECU.