DTC B2007 Open in Seat Belt Motor LH Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2007 | Open in the seat belt motor LH circuit continues for 1 second or more. |
|

| 1.INSPECT FRONT SEAT OUTER BELT ASSEMBLY LH |
![]() |
Disconnect the front seat outer belt assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R8-1 - R8-2 | Always | Below 20 Ω |
Reconnect the front seat outer belt assembly LH connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT BELT CONTROL ECU) |
![]() |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the front seat outer belt assembly LH connector.
Disconnect the seat belt control ECU connector.
Using a service wire, connect 1 and 2 of the connector on the front seat outer belt assembly LH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L2-3 (MOL+) - L2-4 (MOL-) | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Front Seat Outer Belt Assembly LH) |
| *2 | Front view of wire harness connector (to Seat Belt Control ECU) |
Reconnect the seat outer belt assembly LH and seat belt control ECU connectors.
Connect the cable to the negative (-) battery terminal.
|
| ||||
| OK | ||
| ||