TIRE PRESSURE WARNING SYSTEM > DIAGNOSIS SYSTEM |
| CHECK BATTERY VOLTAGE |
| CHECK DLC3 (Click here) |
| DIAGNOSIS SYSTEM |
![]() |
Warning light
When there is a problem with the tire pressure warning system, the tire pressure warning light blinks at 0.5 second intervals, and comes on after 1 minute.
DTCs (Normal mode)
DTCs are memorized in the tire pressure warning ECU and read by the blinks of the tire pressure warning light or by using the Techstream (Click here).
Test mode
By switching from normal mode into test mode (input signal check), you can inspect the tire pressure warning antenna and receiver, each tire pressure warning valve and transmitter, RSSI signal and vehicle speed sensor (Click here).
| CHECK TIRE PRESSURE WARNING LIGHT |
![]() |
Turn the power switch on (IG).
Check that the tire pressure warning light comes on for 3 seconds.
If the warning check result is not normal, proceed to troubleshooting for the tire pressure warning light circuit (Click here).
| TIRE PRESSURE WARNING LIGHT CHART |
| Immediately after turning the power switch on(IG) | Always | |||||||
| Warning light output pattern | ||||||||
| Comes on for 3 sec. | Goes off | Comes on | Blinks for 1 minute and then illuminates*1 | Blinks*2 | Blinks*3 | Blinks*4 | Outputs DTC | |
| Normal | ○ | ○ | - | - | - | - | - | - |
| Low tire pressure | ○ | - | ○ | - | - | - | - | - |
| System fail | ○ | - | - | ○ | - | - | - | - |
| Test mode | ○ | - | - | - | ○ | - | - | - |
| Initialization | ○ | - | - | - | - | ○ | - | - |
| ECU connector poorly connected | - | - | - | ○ *5 | - | - | - | - |
| TC ground (DTC is output) | ○ | - | - | - | - | - | - | ○ |
| TC ground (DTC is not output) | ○ | - | - | - | - | - | ○ | - |
![]() |
![]() |
![]() |
![]() |
![]() |