TIRE PRESSURE WARNING SYSTEM > DTC CHECK / CLEAR |
| DTC CHECK (USING SST CHECK WIRE) |
Turn the power switch off.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the power switch on (IG).
Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration as examples of the normal system code and codes 13 and 23.
| Trouble Area | See Procedure |
| Tire pressure warning light circuit |
Click here
|
| TC and CG terminal circuit |
Click here
|
Refer to Diagnostic Trouble Code Chart (Click here) for DTC information.
After completing the check, turn the power switch off and remove SST from the DLC3.
| DTC CHECK (USING TECHSTREAM) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Read the DTCs following the prompts on the Techstream.
| CLEAR DTC |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Clear the DTCs following prompts on the Techstream.