TIRE PRESSURE WARNING SYSTEM > REGISTRATION |
| 1. DESCRIPTION OF CODE REGISTRATION |
Before registration
When replacing the tire pressure warning ECU:
When replacing a tire pressure warning valve and transmitter:

| 2. REGISTER TRANSMITTER ID (Using Techstream) |
Set the all tire pressure to the specified value (Click here).
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
Perform the following procedures displayed on the screen.
Confirmation of transmitter ID registration.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Read the "ID Tire Inflation Pressure" values.
Confirm that the data of tire pressure of all tires are displayed on the Techstream.