SMART KEY SYSTEM (for Entry Function) > Driver Side Door Entry Lock Function does not Operate |

| 1.CHECK POWER DOOR LOCK OPERATION |
When the door control switch on the master switch assembly is operated, check that the doors unlock and lock according to switch operation (Click here).
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (DOOR LOCK POSITION SWITCH) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FL Door Lock Pos | Driver door lock position switch signal/LOCK or UNLOCK | LOCK: Driver door locked UNLOCK: Driver door unlocked | - |
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (DOOR OUTSIDE HANDLE) |
Enter the following menus: Body Electrical / Smart Key / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D-Door Trigger SW | Driver side door lock switch / ON or OFF | ON: Entry lock switch pressed OFF: Entry lock switch not pressed | - |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - FRONT DOOR OUTSIDE HANDLE) |
Disconnect the certification ECU (smart key ECU assembly) connector.
![]() |
Disconnect the front door outside handle assembly (for driver side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L62-18 (TSW1) - z3-1 (TRG+) | Always | Below 1 Ω |
| L62-18 (TSW1) - Body ground | Always | 10 kΩ or higher |
| z3-1 (TRG+) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
| *2 | Front view of wire harness connector (to Front Door Outside Handle Assembly (for Driver Side)) |
|
| ||||
| OK | |
| 5.INSPECT CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (LOCK SENSOR SIGNAL INPUT) |
Reconnect the certification ECU (smart key ECU assembly) connector.
Reconnect the front door outside handle assembly (for driver side) connector.

Measure the voltage and check for pulses according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L62-18 (TSW1) - L62-15 (E) |
| Pulse generation |
| L62-18 (TSW1) - L62-15 (E) |
| Below 2 V |
| *1 | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) | - | - |
|
| ||||
| OK | ||
| ||