Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Entry Function)

SMART KEY SYSTEM (for Entry Function) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the smart key system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in the problem analysis:

      What
      Vehicle model, system name
      When
      Date, time, occurrence frequency
      Where
      Road conditions
      Under what conditions?
      Running conditions, driving conditions, weather conditions
      How did it happen?
      Problem symptoms


    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage with the power switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally.

      Result:
      Result
      Proceed to
      ECU connected, communication line is normal.
      A
      ECU connected, communication line is malfunctioning.
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM (LIN)*
    1. Use the Techstream to check if the LIN communication system (LIN) is functioning normally (Click here).

      Result:
      Result
      Proceed to
      LIN DTC is not output.
      A
      LIN DTC is output.
      B



    B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    6.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output.

    2. Clear the DTCs.

    3. Recheck for DTCs. Based on the DTCs output, try to cause the same engine immobiliser system DTC, wireless door lock control system DTC or smart key system (for start function) DTC to be output by simulating the symptoms indicated by the DTCs.

      Result:

      Result
      Proceed to
      DTC is not output.
      A
      Engine immobiliser system DTC is output.
      B
      Wireless door lock control system DTC is output.
      C
      Smart key system (for start function) DTC is output.
      D



    B.
    GO TO ENGINE IMMOBILISER SYSTEM (Click here)

    C.
    GO TO WIRELESS DOOR LOCK CONTROL SYSTEM SYSTEM (Click here)

    D.
    GO TO SMART KEY SYSTEM (for Start Function) (Click here)
    A


    7.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      B



    B.
    Go to step 9
    A


    8.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here)

    2. Data List / Active Test (Click here)

    3. Terminals of ECU (Click here)


    NEXT


    9.REPAIR OR REPLACEMENT

      NEXT


      10.CONFIRMATION TEST

        NEXT

        END