FRONT SEAT ASSEMBLY (for Power Seat) > INSTALLATION |
| 1. INSTALL FRONT SEAT ASSEMBLY |
Place the front seat assembly in the cabin.
Connect the connectors under the seat.
Connect the cable to the auxiliary negative (-) battery terminal.
Temporarily install the front seat assembly with the 4 bolts.
Operate the power seat switch knob and move the seat to the rearmost position.
![]() |
Tighten the 2 bolts on the front side of the seat.
Operate the power seat switch knob and move the seat to the foremost position.
![]() |
Tighten the 2 bolts on the rear side of the seat.
| 2. INSTALL INNER SEAT TRACK BRACKET COVER |
Engage the guide and claw to install the inner seat track bracket cover.
| 3. INSTALL OUTER SEAT TRACK BRACKET COVER |
Engage the 2 claws to install the outer seat track bracket cover.
| 4. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 5. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 6. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 7. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
| 8. INSPECT FRONT SEAT ASSEMBLY |
Check the power seat operation (Click here).
Check the seat heater operation.
Turn the power switch on.
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
| 9. INSPECT SRS WARNING LIGHT |