Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE PEDAL STROKE SENSOR

BRAKE PEDAL STROKE SENSOR > REMOVAL

for Preparation Click here


NOTICE:
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



1. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
(Click here)


2. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY


    C247843
  1. Remove the 2 nuts and brake pedal stroke sensor assembly.

    NOTICE:
    1. Do not drop the brake pedal stroke sensor assembly.
    2. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.