FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION |
| 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
![]() |
Engage the guide to temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.
Fully tighten the bolt <A> first, then the bolt <B> to install the front shoulder belt anchor adjuster assembly.
| 2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Temporarily install the front seat outer belt assembly with the 2 bolts.
Fully tighten the bolt <A> first, then the bolt <B> to install the front seat outer belt assembly.
![]() |
Connect the connector and lock the locking button as shown in the illustration.
Connect each connector.
![]() |
Connect the shoulder anchor of the front seat outer belt assembly with the nut.
| 3. INSTALL CENTER PILLAR GARNISH |
Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar garnish LH.
![]() |
Engage the clip.
Install the center pillar garnish LH with the screw.
| 4. INSTALL CENTER PILLAR LOWER GARNISH |
![]() |
Engage the 2 claws and 2 clips to install the center pillar lower garnish LH.
| 5. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Align the alignment mark (Red) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| *1 | Alignment Mark (Red) |
| 6. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Align the alignment mark (Yellow) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
| *1 | Alignment Mark (Yellow) |
| 7. CONNECT FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Install the floor end of the front seat outer belt assembly with the bolt.
Check if the ELR locks.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
| 8. INSTALL LAP BELT OUTER ANCHOR COVER |
![]() |
Engage the 3 claws to install the lap belt outer anchor cover.
| 9. INSTALL REAR DOOR SCUFF PLATE |
![]() |
Engage the 7 claws to install the rear door scuff plate LH.
| 10. INSTALL FRONT DOOR SCUFF PLATE |
![]() |
Engage the 10 claws to install the front door scuff plate LH.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 13. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 14. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
| 15. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).