AUDIO AND VISUAL SYSTEM (w/o Daytime Running Light) > Speaker Circuit |


| 1.CHECK HARNESS AND CONNECTOR |
Disconnect the connectors from the stereo component amplifier assembly and speakers.
Measure the resistance between each of the front No. 1 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| L142-15 (WFR+) - N1-1 | Always | Below 1 Ω |
| L142-30 (WFR-) - N1-2 | Always | Below 1 Ω |
| L142-8 (WFL+) - O1-1 | Always | Below 1 Ω |
| L142-23 (WFL-) - O1-2 | Always | Below 1 Ω |
Measure the resistance between the front No. 2 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| L142-9 (FR+) - I4-1 | Always | Below 1 Ω |
| L142-24 (FR-) - I4-2 | Always | Below 1 Ω |
| L142-14 (FL+) - I5-1 | Always | Below 1 Ω |
| L142-29 (FL-) - I5-2 | Always | Below 1 Ω |
Measure the resistance between each of the rear speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| L142-12 (RR+) - P3-1 | Always | Below 1 Ω |
| L142-27 (RR-) - P3-2 | Always | Below 1 Ω |
| L142-11 (RL+) - Q3-1 | Always | Below 1 Ω |
| L142-26 (RL-) - Q3-2 | Always | Below 1 Ω |
Measure the resistance between each of the rear No. 2 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| L142-13 (TWR+) - P5-1 | Always | Below 1 Ω |
| L142-28 (TWR-) - P5-2 | Always | Below 1 Ω |
| L142-10 (TWL+) - Q5-1 | Always | Below 1 Ω |
| L142-25 (TWL-) - Q5-2 | Always | Below 1 Ω |
Measure the resistance between the stereo component amplifier assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| L142-15 (WFR+) - Body ground | Always | 10 kΩ or higher |
| L142-30 (WFR-) - Body ground | Always | 10 kΩ or higher |
| L142-8 (WFL+) - Body ground | Always | 10 kΩ or higher |
| L142-23 (WFL-) - Body ground | Always | 10 kΩ or higher |
| L142-9 (FR+) - Body ground | Always | 10 kΩ or higher |
| L142-24 (FR-) - Body ground | Always | 10 kΩ or higher |
| L142-14 (FL+) - Body ground | Always | 10 kΩ or higher |
| L142-29 (FL-) - Body ground | Always | 10 kΩ or higher |
| L142-12 (RR+) - Body ground | Always | 10 kΩ or higher |
| L142-27 (RR-) - Body ground | Always | 10 kΩ or higher |
| L142-11 (RL+) - Body ground | Always | 10 kΩ or higher |
| L142-26 (RL-) - Body ground | Always | 10 kΩ or higher |
| L142-13 (TWR+) - Body ground | Always | 10 kΩ or higher |
| L142-28 (TWR-) - Body ground | Always | 10 kΩ or higher |
| L142-10 (TWL+) - Body ground | Always | 10 kΩ or higher |
| L142-25 (TWL-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N1-1 - N1-2 | Always | 4.6 to 6.6 Ω |
| O1-1 - O1-2 | Always | 4.6 to 6.6 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Front No. 1 Speaker Assembly) |
|
| ||||
| OK | |
| 3.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I4-1 - I4-2 | Always | 3.2 to 4.8 Ω |
| I5-1 - I5-2 | Always | 3.2 to 4.8 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Front No. 2 Speaker Assembly) |
|
| ||||
| OK | |
| 4.INSPECT REAR SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P3-1 - P3-2 | Always | 3.2 to 5.2 Ω |
| Q3-1 - Q3-2 | Always | 3.2 to 5.2 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Rear Speaker Assembly) |
|
| ||||
| OK | |
| 5.INSPECT REAR NO. 2 SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P5-1 - P5-2 | Always | 3.2 to 4.8 Ω |
| Q5-1 - Q5-2 | Always | 3.2 to 4.8 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Rear No. 2 Speaker Assembly) |
|
| ||||
| OK | ||
| ||