Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > Mute Signal Circuit between Radio Receiver and Extension Module

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the extension module to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the extension module is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM


E226158E31


INSPECTION PROCEDURE

NOTICE:
After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

1.INSPECT EXTENSION MODULE


    E226639E10
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    z21-1 (MUTE) - Body ground
    Power switch on (ACC), audio system is playing
    → Changing modes
    Above 3.5 V
    → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Extension Module)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE)
  1. Disconnect the radio and display receiver assembly connector.

  1. Disconnect the extension module connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z22-6 (MUTE) - z21-1 (MUTE)
    Always
    Below 1 Ω
    z22-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY (OUTPUT SIGNAL)
  1. Reconnect the radio and display receiver assembly connector.



    E227399E08
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    z21-1 (MUTE) - Body ground
    Power switch on (ACC), audio system is playing
    Above 3.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Extension Module)



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

REPLACE EXTENSION MODULE (Click here)