Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brush Type Motor)

DTC    C1524    Motor Circuit Malfunction

DTC    C1555    Motor Relay Welding Failure

for Preparation Click here


DESCRIPTION

The power steering ECU supplies current to the power steering motor assembly through the motor circuit.

DTC No.
DTC Detection Condition
Trouble Area
C1524
Short (or open) in motor circuit or abnormal voltage in motor circuit
  1. Power steering motor assembly
  2. Power steering ECU assembly
C1555
Predriver (Motor relay circuit) malfunction

WIRING DIAGRAM


C250218E02


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU has been replaced with a new one, perform the assist map writing and the torque sensor zero point calibration (Click here).

1.CHECK POWER STEERING ECU ASSEMBLY
C164820E13
  1. Turn the power switch on (READY).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    (Steering Wheel Position)
    Specified Condition
    z12-1 (M1) - Body ground
    Power switch on (READY)
    (Turned to right)
    Below 1 V
    z12-1 (M1) - Body ground
    Power switch on (READY)
    (Turned to left)
    11 to 14 V
    z12-2 (M2) - Body ground
    Power switch on (READY)
    (Turned to right)
    11 to 14 V
    z12-2 (M2) - Body ground
    Power switch on (READY)
    (Turned to left)
    Below 1 V

    Text in Illustration 
    *1
    Component with harness connected
    (Power Steering ECU Assembly)



NG
REPLACE POWER STEERING ECU ASSEMBLY (Click here)
OK


2.CHECK POWER STEERING MOTOR ASSEMBLY
C164821E09
  1. Disconnect the connector from the power steering ECU assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z12-1 (M1) - z12-2 (M2)
    Always
    0.08 to 0.15 Ω
    z12-1 (M1) - Body ground
    Always
    1 MΩ or higher
    z12-2 (M2) - Body ground
    Always
    1 MΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    ( to Power Steering ECU Assembly)



NG
REPLACE POWER STEERING MOTOR ASSEMBLY (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)